[arm-allstar] How to get FTM-300D working with AllStar voip

[Bill Dornbush]

Kevin,
I tried both cosfrom=usbinvert and cosfrom=usb with the same result
which is no response.  I will try to capture the squelch signal to be sure
it is really there.

Bill AA6BD

On Fri, Feb 2, 2024 at 7:09 PM Kevin Custer <kevin at kc-wireless.com> wrote:

> Bill,
>
> Try using cosfrom=usbinvert
>
> Kevin W3KKC
>
>
>
> On 2/2/2024 4:18 PM, Bill Dornbush via ARM-allstar wrote:
> > I have a Pi3 with a DRA-30 that I am trying to get to work with an
> FTM-300D
> > radio.  I have installed the jumpers on the DRA-30 for COS and CTCSS. I
> > wired the FTM-300D squelch control to the COS pin 2 of the DRA-30.  I set
> > the FTM-300D so that the squelch terminal becomes active when either the
> TX
> > or RX band squelch is open and I set the band programmed to the frequency
> > for the hotspot operation.  I have a FT1-XDR HT programmed to the same
> > frequency.  I can send a DTMF sequence using Supermon and the node
> > responds.  In the simpleusb-tune-menu, I have COSFROM set to usb and
> > CTCSSFROM to no.  I ran Asterisk CLI client, and I see that
> simpleusb_read
> > reports that it got DTMF characters when I key the HT.  But the node does
> > not act on the DTMF sequence.  What am I missing?
> >
> > AA6BD
> > _______________________________________________
> >
> > ARM-allstar mailing list
> > ARM-allstar at hamvoip.org
> > http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> >
> > Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
>
>