[arm-allstar] How to get FTM-300D working with AllStar voip

[Kevin Custer]

Bill,

Try using cosfrom=usbinvert

Kevin W3KKC



On 2/2/2024 4:18 PM, Bill Dornbush via ARM-allstar wrote:
> I have a Pi3 with a DRA-30 that I am trying to get to work with an FTM-300D
> radio.  I have installed the jumpers on the DRA-30 for COS and CTCSS. I
> wired the FTM-300D squelch control to the COS pin 2 of the DRA-30.  I set
> the FTM-300D so that the squelch terminal becomes active when either the TX
> or RX band squelch is open and I set the band programmed to the frequency
> for the hotspot operation.  I have a FT1-XDR HT programmed to the same
> frequency.  I can send a DTMF sequence using Supermon and the node
> responds.  In the simpleusb-tune-menu, I have COSFROM set to usb and
> CTCSSFROM to no.  I ran Asterisk CLI client, and I see that simpleusb_read
> reports that it got DTMF characters when I key the HT.  But the node does
> not act on the DTMF sequence.  What am I missing?
>
> AA6BD
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org