[arm-allstar] How to get FTM-300D working with AllStar voip

[Bill Dornbush]

I have a Pi3 with a DRA-30 that I am trying to get to work with an FTM-300D
radio.  I have installed the jumpers on the DRA-30 for COS and CTCSS. I
wired the FTM-300D squelch control to the COS pin 2 of the DRA-30.  I set
the FTM-300D so that the squelch terminal becomes active when either the TX
or RX band squelch is open and I set the band programmed to the frequency
for the hotspot operation.  I have a FT1-XDR HT programmed to the same
frequency.  I can send a DTMF sequence using Supermon and the node
responds.  In the simpleusb-tune-menu, I have COSFROM set to usb and
CTCSSFROM to no.  I ran Asterisk CLI client, and I see that simpleusb_read
reports that it got DTMF characters when I key the HT.  But the node does
not act on the DTMF sequence.  What am I missing?

AA6BD