[arm-allstar] HamVoip on Pi3a

[Jason]

I've been running Hamvoip on a Pi 3A+ since the board came out. I do have a
Pi Zero 2 that had the wifi chip go bad and I'm currently using it as a
Pi-HoleUnbound server with a wifi dongle until I get around to soldering
headers on a couple new Pi Zero 2 boards. I've heard the TGIF Spot seller
say he's seen issues with the wfi chips going bad on occasion. Couple
things you could try, throw a fresh Raspberry Pi image on it and make sure
it's working properly with wifi. And then maybe try a fresh install of
Hamvoip. Corruption of SD cards can cause all kinds of weird issues, and
you can use F3 Tools <https://github.com/AltraMayor/f3> with a Linux system
to check the card, then write to the whole thing and then read it to make
sure its good. I just threw out a card that failed testing which caused
issues with one of my Pi-Hole/unbound servers.

Jason - WY7JT

On Fri, Feb 2, 2024 at 7:04 AM David McGough via ARM-allstar <
arm-allstar at hamvoip.org> wrote:

>
> Tony,
>
> I have many RPi3A+ boards running HamVoIP, no issues.  However, I did hear
> one report of a person with issues. They said the problem was with a
> recently purchased RPi3A+ and a hardware rev change.....So, I purchased a
> couple new 3A+ boards and couple not duplicate the issue??
>
> I guess I'll throw the question out to the group then:  Anyone else having
> problems with 3A+ boards, running the most recent HamVoIP firmware
> download?    If there is an issue, I'll look at resolving it ASAP!
>
> 73, David K4FXC
>
>