[arm-allstar] Help with home built Allstar node

[Steve Agee]

*Since it briefly receives then switches to transmit, it sounds like you 
have it configured for a full duplex repeater, which is the default. You 
can convert it to a simplex node by editing the /etc/asterisk/rpt.conf 
file and adding the following line, or changing it if it already exists:

[49876]

duplex = 1

Then restart asterisk or reboot.

N5ZUA
*
On 3/4/2022 7:01 AM, "Phil Hazelton via ARM-allstar" wrote:
> Hi All,
> I’m new to Allstar. I am building a new node, using a Pi 3, Hamvoip soft ware, Baofeng 888 and a modified CM 108 usb sound card. After much effort, it seems it is nearly working. All star sees my node, and the radios are talking to each other on power up. However, when I turn on my node, the 888 starts to Tx and stays Tx’ing until the 888 Tx default time out kicks in. When I PTT my external ht the node briefly goes into Rx, then again defaults to Tx for the default period.
> Any help/ideas would be appreciated.
> Thanks,
> Phil, G8PJH
> Sent from my iPad
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page -http://hamvoip.org