[arm-allstar] Not Connecting to Nodes

[Dave Petrie]

Try resetting your Internet Router, by that i mean just power cycle it, if
you are using the same IP on the new Raspberry, two different devices using
the same local IP they have different MAC addresses and some routers can't
handle it.

On Sun, Apr 24, 2022 at 1:32 PM "Jason Trbovich via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> Hello all,
>
> I have a question that I hope someone can help me answer.
>
> I recently built a new AllStar Node via the Raspberry Pi, Baofeng 888S and
> CM108 sound card combo.
>
> To test it out, I decided to shut down and power off my “yellow box” node
> (a Raspberry Pi, Baofeng 888S and sound card combo) and just test with the
> node number that I use on that unit.
>
> I powered on the new unit, ran the firsttime.sh file, set everything up,
> etc., etc.
>
> The problem is that I cannot connect to any nodes with this new box that I
> built. The node shows up as being  registered on the allstar web page but I
> can’t connect to any nodes. I also use a remote application to control my
> box and it does not work even when I enter the new password and ip address.
>
> I have checked all of the usual suspects in the rpt.conf, manager.conf,
> iax.conf, etc., and still the same result.
>
> The funny thing is that when I shut down the new box and go back to the
> old “yellow box” , everything works normally.
>
> Does anyone know what I did wrong or could they point me in the right
> direction?
>
> Thank you,
>
> Jason - KG5PDM
>
>
>
> Sent from my iPhone
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org