[arm-allstar] Not Connecting to Nodes

[Jason Trbovich]

Hello all, 

I have a question that I hope someone can help me answer. 

I recently built a new AllStar Node via the Raspberry Pi, Baofeng 888S and CM108 sound card combo. 

To test it out, I decided to shut down and power off my “yellow box” node (a Raspberry Pi, Baofeng 888S and sound card combo) and just test with the node number that I use on that unit. 

I powered on the new unit, ran the firsttime.sh file, set everything up, etc., etc. 

The problem is that I cannot connect to any nodes with this new box that I built. The node shows up as being  registered on the allstar web page but I can’t connect to any nodes. I also use a remote application to control my box and it does not work even when I enter the new password and ip address. 

I have checked all of the usual suspects in the rpt.conf, manager.conf, iax.conf, etc., and still the same result. 

The funny thing is that when I shut down the new box and go back to the old “yellow box” , everything works normally. 

Does anyone know what I did wrong or could they point me in the right direction? 

Thank you, 

Jason - KG5PDM 



Sent from my iPhone