[arm-allstar] Not Connecting to Nodes

[Les Keegan]

When you set up your port forwarding from your internet router did you name your first node and directed it to know which device to forward the port to? If so when you set up the second node to port forward it probably has a different name and it is not assigned the same port number. So if your first one is set up to open port 4569 then set the second one up to 4570 and it should work.

Les Keegan
N4LPK






> On 04/24/2022 1:17 PM Jason Trbovich via .> ARM-allstar <arm-allstar at hamvoip.org> wrote:
> 
>  
> Hello all, 
> 
> I have a question that I hope someone can help me answer. 
> 
> I recently built a new AllStar Node via the Raspberry Pi, Baofeng 888S and CM108 sound card combo. 
> 
> To test it out, I decided to shut down and power off my “yellow box” node (a Raspberry Pi, Baofeng 888S and sound card combo) and just test with the node number that I use on that unit. 
> 
nter> The problem is that I cannot connect to any nodes wth this new box that I built. The node shows up as being  registered on the allstar web page but I can’t connect to any nodes. I also use a remote application to control my box and it does not work even when I enter the new password and ip address. 
> 
> I have checked all of the usual suspects in the rpt.conf, manager.conf, iax.conf, etc., and still the same result. 
> 
> The funny thing is that when I shut down the new box and go back to the old “yellow box” , everything works normally. 
> 
> Does anyone know what I did wrong or could they point me in the right direction? 
> 
> Thank you, 
> 
> Jason - KG5PDM 
> 
> 
> 
> Sent from my iPhone
> _______________________________________________
> 
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> 
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org