[arm-allstar] outxlat across two nodes on the same Pi

[Patrick Perdue]

Here's the situation.

A club has a repeater on an existing Rc-210 controller with two ports. 
Port 1 is the repeater itself. Port 2 is a HamVoIP node connected to a 
URI. The club wants to also connect a Yaesu HRI-200 in analog mode to 
the repeater, but there are no more ports left. Suggested building a 
cable and connecting it to another sound fob, putting it on a private 
node, then connecting the two nodes together.

However, now they need a way to control the WIRES x software from the 
repeater over DTMF.

I have done this with outxlat, but this is only good if you are sending 
commands directly from the node you want to send local DTMF through. In 
this case, node 1 is connected to the repeater, and node 2 is connected 
to the HRI-200. Node 2 needs to receive arbitrary DTMF strings to send 
off to the HRI-200, which will then be interpreted by the WIRES x 
software at the other end.

How an this be accomplished?

If outxlat is used on node 1, it will just send DTMF to that output, not 
to the fob attached to node 2.

73

N2DYI