[arm-allstar] outxlat across two nodes on the same Pi

[Steve Mobley - WB4BXO]

If you’re talking about an Arcom RC-210, it has three ports. 

Steve Mobley - WB4BXO
--- hello, I am an iApp-oholic...

> On Oct 7, 2021, at 6:01 AM, Patrick Perdue via ARM-allstar <arm-allstar at hamvoip.org> wrote:
> 
> Here's the situation.
> 
> A club has a repeater on an existing Rc-210 controller with two ports. Port 1 is the repeater itself. Port 2 is a HamVoIP node connected to a URI. The club wants to also connect a Yaesu HRI-200 in analog mode to the repeater, but there are no more ports left. Suggested building a cable and connecting it to another sound fob, putting it on a private node, then connecting the two nodes together.
> 
> However, now they need a way to control the WIRES x software from the repeater over DTMF.
> 
> I have done this with outxlat, but this is only good if you are sending commands directly from the node you want to send local DTMF through. In this case, node 1 is connected to the repeater, and node 2 is connected to the HRI-200. Node 2 needs to receive arbitrary DTMF strings to send off to the HRI-200, which will then be interpreted by the WIRES x software at the other end.
> 
> How an this be accomplished?
> 
> If outxlat is used on node 1, it will just send DTMF to that output, not to the fob attached to node 2.
> 
> 73
> 
> N2DYI
> 
> _______________________________________________
> 
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> 
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org