[arm-allstar] Check your echolink settings!

James R. Pilgram jim.pilgram at gmail.com
Thu Jan 14 13:22:09 EST 2021


Aloha David,
My echolink doesn't have a repeater associated with it but is usually
connected to my hub which also has no RF so *MUST* is a bit confusing me.
Care to elaborate?

73 & Aloha
Jim NH6HI


On Thu, Jan 14, 2021, 06:33 "David McGough via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

>
> Hi Everyone,
>
> It came to my attention this morning that some HamVoIP echolink users are
> not updating the default station APRS configuration and location info
> which gets reported to the echolink database.  Here are the DEFAULT
> setting, as found in the sample echolink configuration:
>
> ; Change following setting to your parameters
> freq=446.1
> tone=88.5
> lat=40.223976
> lon=-75.008529
> power=20
> height=50
> gain=6
> dir=0
>
>
> These settings *MUST* be updated with the specific configuration and
> location of you station, not just left as defaults!  If you don't know
> your physical station latitude (lat) or longitude (lon), a couple
> sources where you can find that position are via https://www.qrz.com or
> https://aprs.fi
>
>
> Thanks,
>
> 73, David KB4FXC
>
>
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
>


More information about the ARM-allstar mailing list