[arm-allstar] Link Radio COS/CTCSS Staying On

[David McGough]

Mike,

I'm not sure I fully understand your linking scenario. But, try reversing
the linktolink setting.

On the CAT250 interface, duplex=0, linktolink=no

And, on the XPR2500, duplex=0, linktolink=yes

Then, anytime the repeater RX is active, the XPR2500 should go PTT active, 
even if the XPR2500 has COS active.

Is this what you're wanting?

73, David KB4FXC


On Mon, 28 Sep 2020, "Mike Sullivan via ARM-allstar" wrote:

> I have an issue with one of the nodes I am working on. The node is
> connected to a repeater via a CAT 250 and a RIM-Lite, and a local node is
> set up on a second RIM-Lite with a Motorola XPR2500. Everything is set up
> properly as per the instructions on Scott's site, the repeater is duplex=0,
> linktolink=yes and the link node is duplex=0, linktolink=yes is commented
> out.
> 
> If someone talks on the repeater while the link is idle, there is no
> problem with audio passing through. However, if the link is in receive, and
> someone keys up on the repeater, the repeater and link both show
> Full-Duplex which does not allow audio to pass thru correctly. Watching it
> in Supermon as well confirms that COS, CTCSS, and PTT are all keyed. The
> link radio uses usbinvert in Supermon and I believe the radio is set for
> Active Low, so I'm pretty sure it is set up correctly. Any idea why this
> would be happening?
> 
> Mike
> _______________________________________________
> 
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> 
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
>