[arm-allstar] CW ID 10 min

[Danny K5CG]

That would not take into account PTT from linked machines. Rats.

----- Original Message -----
> From: "Danny K5CG" <k5cg at hamoperator.org>
> To: "ARM Allstar" <arm-allstar at hamvoip.org>
> Sent: Tuesday, September 22, 2020 10:56:28 PM
> Subject: Re: [arm-allstar] CW ID 10 min

> A way I can think of doing this (if app_rpt can't) would be to watch COS with an
> event an if there has been no RX activity for 15 minutes, then set a GPIO pin
> to turn off power to the transmitter. Turn the transmitter back on when there
> is COS activity again.
> 
> That's just my hack at it.
> 
> ----- Original Message -----
>> From: "Ron WA2WWK via ARM-allstar" <arm-allstar at hamvoip.org>
>> To: "ARM Allstar" <arm-allstar at hamvoip.org>
>> Cc: "Ron WA2WWK" <wa2wwk at gmail.com>
>> Sent: Tuesday, September 22, 2020 8:15:53 PM
>> Subject: [arm-allstar] CW ID 10 min
> 
>> Is there a way to allow CW ID only when node is in use (10  min) not every
>> hour?  Thanks.  Ron
>> _______________________________________________
>> 
>> ARM-allstar mailing list
>> ARM-allstar at hamvoip.org
>> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>> 
> > Visit the BBB and RPi2/3/4 web page - http://hamvoip.org