[arm-allstar] CW ID 10 min

[Ron WA2WWK]

Looked into this and realized that both Time and ID occurs 24/7 on the
hour.  Looked at cron.hourly but couldn't determine what was triggering
this event.  My thought is if node has no activity after the last QSO then
no Time or ID should be necessary???  Maybe I'm not seeing something.

On Wed, Sep 23, 2020 at 12:53 AM "Danny K5CG via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> That would not take into account PTT from linked machines. Rats.
>
> ----- Original Message -----
> > From: "Danny K5CG" <k5cg at hamoperator.org>
> > To: "ARM Allstar" <arm-allstar at hamvoip.org>
> > Sent: Tuesday, September 22, 2020 10:56:28 PM
> > Subject: Re: [arm-allstar] CW ID 10 min
>
> > A way I can think of doing this (if app_rpt can't) would be to watch COS
> with an
> > event an if there has been no RX activity for 15 minutes, then set a
> GPIO pin
> > to turn off power to the transmitter. Turn the transmitter back on when
> there
> > is COS activity again.
> >
> > That's just my hack at it.
> >
> > ----- Original Message -----
> >> From: "Ron WA2WWK via ARM-allstar" <arm-allstar at hamvoip.org>
> >> To: "ARM Allstar" <arm-allstar at hamvoip.org>
> >> Cc: "Ron WA2WWK" <wa2wwk at gmail.com>
> >> Sent: Tuesday, September 22, 2020 8:15:53 PM
> >> Subject: [arm-allstar] CW ID 10 min
> >
> >> Is there a way to allow CW ID only when node is in use (10  min) not
> every
> >> hour?  Thanks.  Ron
> >> _______________________________________________
> >>
> >> ARM-allstar mailing list
> >> ARM-allstar at hamvoip.org
> >> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> >>
> > > Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
>