[arm-allstar] Voice announcements to weak to hear.

[Doug Crompton]

Lee,

   Telemetry (announcement) levels are set by two parameters in rpt.conf,

telemnomdb=0    ; Overall reduction in telemetry level
telemduckdb=-9   ; Telemetry level reduction with signal

First you must set the overall level using simpleusb-tune-menu  Then
telemnomdb sets the amount the telemetry messages are incresed or decreased
in relation to normal voice. This is usually set at 0 dB or some amount
lower, say -3 dB.  telemduckdb is how much lower telemetry is when it is
over top of someone talking.

Check your levels and these parameters. There is nothing else that could
effect it.


*73 Doug*

*WA3DSP*

*http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*


On Wed, May 27, 2020 at 12:43 PM "Les Keegan via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> I've been running a node using Hamvoip and a DMK URI and up to now it has
> worked fine. But all of a sudden the announcement volume became very low
> almost unreadable. I can pass DTMF and my transmit audio is fine. I just
> cannot hear when someone connects.
>
> Les Keegan-N4LPK
>
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
>