[arm-allstar] command to disable transmit?

[Orrin Winton]

On Fri, Jan 17, 2020 at 10:13 PM "Doug Crompton via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

>   Yes, the receiver continues to operate and you can send DTMF commands to
> it. It disables the transmit and and further connections to the node. Any
> existing connections when you do the disable remain.
>
> The command in the client is -  rpt cmd 1998 cop 3     - to disable
>                                                rpt cmd 1998 cop 2     - to
> enable.  Voice saying R P T E N A will be heard.
>

OK: at the alarmpi*CLI prompt, i typed: rpt cmd <mynode#> cop 2
And i heard RPTENA. And that *did* disable the xmit on the radio.
On my HT i then did *82, and nothing came back on the RF side but it did
give the time on my DVSwitch client. Fine.

But then typing:   rpt cmd <mynode#> cop 3
Seemed to do nothing. Did not restore the radio xmit. So i did
rpt cmd <mynode#> cop 2
again, and that restored the radio.

Is this how it works? Thanks

Orrin wn1z