[arm-allstar] New Netgate (PFsense) router

[Joe Moskalski]

It sounds like you need to create an associated firewall rule to allow
traffic ton po ass on that port.

On Wed, Dec 9, 2020, 12:25 PM "Fred Hillhouse via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> Greetings,
>
> I took an older and non-upgradable router out of service and replaced it
> with a Netgate router. It runs PFsense.
> I added Port Forward to the AllStar (Hamvoip) RPi with port 4569.
> I added Dynamic DNS Client matching my DNS alias service.
> AllStar (Hamvoip) is current.
> I assigned the node to a fixed IP.
>
> From Supermon2, I am not able to connect to any other nodes.
> When I attempt to connect to my node, 46148, from DVSwitch, it doesn't.
>
> Obviously I missed something!
> Any hints as to what I may have missed in my router setup or otherwise?
> Can you connect to node 46148?
>
> I did manage to connect to another node once (using Supermon2) but no
> longer.
>
> Thank you!
>
> Best regards,
> Fred N7FMH
>
> PS. There is a lesson here! Check service before changing the
> infrastructure
> it relies on. What I failed to do was check to make sure I could connect
> using my older router before taking it down. I had not connected from my
> phone in over a month. But, I found I missed a couple of other items too!
> :(
>
>
> --
> This email has been checked for viruses by Avast antivirus software.
> https://www.avast.com/antivirus
>
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
>