[arm-allstar] local nodes not connecting, no log messages

[John Simmons]

Been there too

-de John NI0K

"Richard Bateman via ARM-allstar" wrote on 10/7/2019 3:28 PM:
> Now that I finally asked for help I have of course realized that I was
> sending the command wrong; I guess if you send a command it doesn't
> recognize it just ignores it. I feel kinda dumb, but at least I figured it
> out =]
>
> Richard
>
> On Mon, Oct 7, 2019 at 2:13 PM Richard Bateman <richard at batemansr.us> wrote:
>
>> Hi,
>>
>> I just upgraded my controller to a raspberry pi 4 and put three nodes on
>> the same controller; I previously had only two. I want to link all three
>> together (2m, 70cm, 1.25m) and I'm using the same rpt.conf file that was
>> working before, but I copied the relevant sections from the iax2.conf file
>> as well and extensions.conf. I grepped for the node numbers and everywhere
>> that there is one I have all three, as appropriate.
>>
>> Even if I messed that up somewhere I should at least be able to connect
>> the two nodes that were previously together since I started with that
>> config file, but when I tell it to connect nothing happens -- literally
>> nothing. No log message, no "can't connect" message, nothing at all.
>>
>> These nodes have public node numbers but I'm trying to connect directly,
>> using the ip address and port configuration defined in the [nodes] section
>> of the config file.
>>
>> Any suggestions for where to start troubleshooting? I've had it all
>> working before but I can't seem to get anything to work.
>>
>> Node numbers are 44068, 44072, and 46516
>>
>> Richard
>>
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org