[arm-allstar] local nodes not connecting, no log messages

[Richard Bateman]

Now that I finally asked for help I have of course realized that I was
sending the command wrong; I guess if you send a command it doesn't
recognize it just ignores it. I feel kinda dumb, but at least I figured it
out =]

Richard

On Mon, Oct 7, 2019 at 2:13 PM Richard Bateman <richard at batemansr.us> wrote:

> Hi,
>
> I just upgraded my controller to a raspberry pi 4 and put three nodes on
> the same controller; I previously had only two. I want to link all three
> together (2m, 70cm, 1.25m) and I'm using the same rpt.conf file that was
> working before, but I copied the relevant sections from the iax2.conf file
> as well and extensions.conf. I grepped for the node numbers and everywhere
> that there is one I have all three, as appropriate.
>
> Even if I messed that up somewhere I should at least be able to connect
> the two nodes that were previously together since I started with that
> config file, but when I tell it to connect nothing happens -- literally
> nothing. No log message, no "can't connect" message, nothing at all.
>
> These nodes have public node numbers but I'm trying to connect directly,
> using the ip address and port configuration defined in the [nodes] section
> of the config file.
>
> Any suggestions for where to start troubleshooting? I've had it all
> working before but I can't seem to get anything to work.
>
> Node numbers are 44068, 44072, and 46516
>
> Richard
>