[arm-allstar] audio on the cdm1250

[Jed Barton]

Do i do this in the radio cps? Yea, it's set for flat audio.  Just
curious, do you run a cdm, and what do you have it set to?

Cheers,

Jed

On 11/10/19, "David McGough via ARM-allstar" <arm-allstar at hamvoip.org> wrote:
>
> Jed,
>
> You've likely got the cmd1250 setup for "flat" audio. Try turning on
> pre-emphasis in simpleusb-tune-menu. Note that you can do this real-time,
> even while transmitting. You can try turning on/off and listen to the
> difference.
>
> 73, David KB4FXC
>
>
> On Sun, 10 Nov 2019, "Jed Barton via ARM-allstar" wrote:
>
>> Hey guys,
>>
>> n1jbc here.  So, after a lot of work we finally got my cdm1250 working
>> with the uri board, and hamvoip software. yea!
>> So, here's a question.  I wanna see if i can get a little better
>> transmit audio out of the cdm's transmitter.  There seems to be a lot
>> of low end audio, and not so much high end.  Any ideas on what we can
>> play with?
>> Is it something we change in the radio code plug, or in hamvoip?
>> We're running a UHF cdm1250 along with 1 of Marshal's cables, and the
>> uri board.
>>
>> Cheers,
>>
>> Jed
>> _______________________________________________
>>
>> ARM-allstar mailing list
>> ARM-allstar at hamvoip.org
>> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>>
>> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>>
>
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>