[arm-allstar] Supermon stopped working after re-start

[Doug Crompton]

Ron,

 If you didn't turn it off the node announces its IP address at boot. The
IP address is also sent in morse code to the Pi LED twice at boot preceded
by HI HI. I suspect your IP address changed if you are using DHCP and you
did not make it reserved or permanent in your router.


*73 Doug*

*WA3DSP*

*http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*

On Sat, Mar 30, 2019 at 6:23 PM "Ron Gilson via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> I recently set up Supermon on Node 41893.  Things seemed to work very well
> until earlier today when I decided to shut down via putty so I could
> re-route power thru a ups backup.  After that the Supermon would no longer
> work , putty and WinScp also could not access the node.  I looked on my
> router and the IP is correct but I'm not able to ping 41893 from my LAN.  I
> can dial up a connection to 27225 & and DTMF for ID, Time etc work well.
> Any ideas other than start over again?  My other node on same LAN different
> LAN IP has no problem?  Thanks for your help.
> WA2WWK  Ron
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>