[arm-allstar] Supermon stopped working after re-start
Ron Gilson
wa2wwk at gmail.com
Sun Mar 31 17:53:43 EDT 2019
Thanks will check in am but the node looked like it stayed at .24. Enjoy
the balance of the weekend. 73's
Ron WA2WWK
On Sat, Mar 30, 2019 at 6:35 PM "Doug Crompton via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:
> Ron,
>
> If you didn't turn it off the node announces its IP address at boot. The
> IP address is also sent in morse code to the Pi LED twice at boot preceded
> by HI HI. I suspect your IP address changed if you are using DHCP and you
> did not make it reserved or permanent in your router.
>
>
> *73 Doug*
>
> *WA3DSP*
>
> *http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*
>
> On Sat, Mar 30, 2019 at 6:23 PM "Ron Gilson via ARM-allstar" <
> arm-allstar at hamvoip.org> wrote:
>
> > I recently set up Supermon on Node 41893. Things seemed to work very
> well
> > until earlier today when I decided to shut down via putty so I could
> > re-route power thru a ups backup. After that the Supermon would no
> longer
> > work , putty and WinScp also could not access the node. I looked on my
> > router and the IP is correct but I'm not able to ping 41893 from my
> LAN. I
> > can dial up a connection to 27225 & and DTMF for ID, Time etc work well.
> > Any ideas other than start over again? My other node on same LAN
> different
> > LAN IP has no problem? Thanks for your help.
> > WA2WWK Ron
> > _______________________________________________
> >
> > ARM-allstar mailing list
> > ARM-allstar at hamvoip.org
> > http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> >
> > Visit the BBB and RPi2/3 web page - http://hamvoip.org
> >
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>
More information about the ARM-allstar
mailing list