[arm-allstar] Cross Band Repeater with DMK URI Possible?

[David McGough]

Sure, that'll work fine, but, it'll require 2 URI's. Setup each node as a 
simplex node (duplex=1) and then link both nodes together.

Obviously watch out for TX duty cycle on either radio.

73, David KB4FXC



On Fri, 12 Jul 2019, "Kyle Krieg via ARM-allstar" wrote:

> Our club and area hams provide bike event support in September for a
> 150mile, 2 day 1500 bike fundraiser.
> 
> One of the longer routes on Sunday requires us to use 2m to a centrally
> located school for the SAG vans and rest stops and then a 70cm yagi link
> back to net control at the area college so we don't step on any of the
> remaining 2m simplex frequencies.
> 
> I have a couple of old ICOM radios with external pin outs here I can throw
> together.
> 
> Would AllStar have the capability with full duplex mode to configure it for
> a full cross band repeater with a 2m and 70cm radio?  In/out 70cm and
> in/out 2m?
> 
> Running HamVoIP into a Pi.
> 
> Kyle
> AA0Z
> _______________________________________________
> 
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> 
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>