[arm-allstar] Cross Band Repeater with DMK URI Possible?

[Jay Urish]

Or--

just a crossband radio like a V71a



On 7/12/19 4:02 PM, "David McGough via ARM-allstar" wrote:
>
> Sure, that'll work fine, but, it'll require 2 URI's. Setup each node as a
> simplex node (duplex=1) and then link both nodes together.
>
> Obviously watch out for TX duty cycle on either radio.
>
> 73, David KB4FXC
>
>
>
> On Fri, 12 Jul 2019, "Kyle Krieg via ARM-allstar" wrote:
>
>> Our club and area hams provide bike event support in September for a
>> 150mile, 2 day 1500 bike fundraiser.
>>
>> One of the longer routes on Sunday requires us to use 2m to a centrally
>> located school for the SAG vans and rest stops and then a 70cm yagi link
>> back to net control at the area college so we don't step on any of the
>> remaining 2m simplex frequencies.
>>
>> I have a couple of old ICOM radios with external pin outs here I can throw
>> together.
>>
>> Would AllStar have the capability with full duplex mode to configure it for
>> a full cross band repeater with a 2m and 70cm radio?  In/out 70cm and
>> in/out 2m?
>>
>> Running HamVoIP into a Pi.
>>
>> Kyle
>> AA0Z
>> _______________________________________________
>>
>> ARM-allstar mailing list
>> ARM-allstar at hamvoip.org
>> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>>
>> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>>
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org