[arm-allstar] Hamvoip Shutdown Script

[Sean McCarthy]

Right. How can I check if the script is running without simulating a power
loss?

On Fri, Jul 13, 2018 at 3:20 PM, "Doug Crompton via arm-allstar" <
arm-allstar at hamvoip.org> wrote:

> Sean,
>
>  The shutdown_monitor script is intended to work with the GPIO bit to
> signal shutdown. All you have to do is pull the pwr_good pin, defined as
> wiringpi pin 1 actual physical pin 11, low for about 5 seconds and it will
> enter the shutdown state
>
> This is discussed in two howto on the hamvoip.org web page
>
> https://hamvoip.org/hamradio/power_shutdown_monitor/
>
> https://hamvoip.org/hamradio/RPi2_halt_switch/
>
> The shutdown_monitor is designed to work with the power shutdown board but
> will work with any outside source that lower that pin at power failure. The
> shutdown board uses a small battery to power the Pi during the shutdown
> process which takes about 15 seconds.
>
>
> *73 Doug*
>
> *WA3DSP*
>
> *http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*
>
>
>
> On Fri, Jul 13, 2018 at 2:44 PM, "Sean McCarthy via arm-allstar" <
> arm-allstar at hamvoip.org> wrote:
>
> > Besides simulating a power loss, how can I verify the shutdown script is
> > running?
> >
> > I have "enabled" shutdown in allstar.env and rebooted.
> >
> > Thanks,
> > Sean
> > _______________________________________________
> >
> > arm-allstar mailing list
> > arm-allstar at hamvoip.org
> > http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> >
> > Visit the BBB and RPi2/3 web page - http://hamvoip.org
> >
> _______________________________________________
>
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>