[arm-allstar] Where to do CTCSS decoding in a voting config?

[Tim Sawyer]

Doug,

Check out our RTCM documentation at http://wiki.allstarlink.org/. On the
mage page you will see 2 sections, one for the RTCM and one for the server,
under the RTCM Info heading.

With the RTCM channel driver there is no CTCSS decode as in usbradio. Your
receiver must provide CTCSS detection.

Echolink works the same on all AllStar nodes. It's setup is independent of
rxchannel.

On Sun, Dec 31, 2017 at 10:50 PM, "Doug Kingston via arm-allstar" <
arm-allstar at hamvoip.org> wrote:

> I am in the process of prototyping a multi-site repeater configuration
> using RTCM boxes and Pi3's for a Seattle repeater system.  I am little
> confused about where to do the CTCSS decode.  Can that be done by Asterisk
> or should I do that in each receiver and feed that decode signal to the
> RTCM on pin 4?
>
> What's the best documentation on setting up asterisk for voter usage? (I
> only found the reference to changing rxchannel by accident in an email to
> this list)
> How about how to integrate Echolink and IRLP?
> Sample working config files (sans passwords)?
>
> -Doug-, KD7DK
> _______________________________________________
>
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>



-- 
Tim WD6AWP