[arm-allstar] usbradio

[David McGough]

Hi Tom,

Your configuration looks like it should work as a starting point with 
usbradio.....While we don't talk about is much, usbradio is fully 
operable in the hamvoip release. However, you will likely have some audio 
pops and clicks, due to the DSP demands placed on the RPi hardware.

What duplex mode is your node using in the rpt.conf [1999] node stanza?

What type radio/repeater are you interfacing with?

73, David KB4FXC



On Sun, 11 Feb 2018, "Tom Eaton via arm-allstar" wrote:

> I am running 1.5rc4-14 and want to use usbradio and not simpleusb, I have
> set it up but cannot get it to work. these is the files. Works fine in
> simpleusb but when I change to usbradio radio-tune-menu will come up but it
> shows no audio on rx and will not tx, I am trying to test on a working node
> for a new rx only node that has no cos on receiver. Any help would be great.
> 
> Thanks
> Tom KC4CBQ
> 
> [usb1999]
> 
> hdwtype=1
> rxboost=1
> txboost=1
> rxctcssrelax=1
> txctcssdefault=100.0
> rxctcssfreqs=186.2
> txctcssfreqs=186.2
> ;rxctcssoverride=0
> carrierfrom=dsp
> ctcssfrom=dsp
> rxdemod=flat
> txprelim=yes
> txlimonly=no
> txtoctype=notone
> txmixa=composite
> txmixb=0
> invertptt=0
> duplex=1
> rxondelay=0
> rxnoisefiltype=0
> eeprom=0
> 
> #includeifexists custom/usbradio.conf
> 
> 
> 
> 
> [1999] ; Change this to your assigned node number
> 
> ; Channel Driver settings
> ; Define a channel driver to use and which
> ; interface within that channel driver
> ; To define a radioless node use the
> ; psuedo channel driver - rxchannel=dahdi/pseudo
> rxchannel=Radio/usb1999
> ; Example usbradio channel driver
> ;rxchannel=SimpleUSB/usb
> ; Example simpleusb channel driver
> ;rxchannel=dahdi/pseudo
>