[arm-allstar] Simple_USB_Tune Menu

[Doug Crompton]

Jim,

 It sounds like you are not going to have enough drive with the FOB you are
using. If it is a DMK-URI here is an additional amplifier you can jumper in.

Connect pins  24-14  and pins 22-24 and take the output to the TX from pin
12

This connects 5V to the additional op-amp and puts it in circuit. This
should give you enough additional gain. If not you can disconnect the 24-14
connection and put up to 12V on pin 24.

There are other FOBS like the RA35 that would have the additional output
required.


*73 Doug*

*WA3DSP*

*http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*





On Fri, Aug 17, 2018 at 7:32 AM, "James R. Pilgram via arm-allstar" <
arm-allstar at hamvoip.org> wrote:

> Aloha,
>
> Is there a "poop sheet" on the simple USB Tune menu? In particular I
> looking at item E) Toggle Transmit Test Tone/Keying
>
> What is the Tone Frequency and level? I need to set the wireline input on
> my MTR2000 Repeater it's calling for a 1khz tone with a level of 0 to -30
> dbm.
>
> The transmit A level is at 999 and I still cant get enough audio level out
> of the TX side of the repeater. The adjustment is done in the Radio Service
> Software.
>
> Using the setup at http://www.repeater-builder.co
> m/motorola/mtr2k/more-mtr2k-int/mtr2000-interfacing-followup.html
>
> Jim NH6HI
>
> _______________________________________________
>
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>