[arm-allstar] Simplex Mode 1 Issues

[Eric Harrison]

I have experience the same issue in duplex mode 1 and turning the hangtime to ZERO.
There is still a ping pong effect that occurs because of the repeaters squelch hangtime.  

if you want to run Duplex mode 1 to gain your telemetry your link to the repeater will need to be
a simplex link or run ctcss on the repeater only when a cos signal is present. The S-comm 7330 
controller I use has this capability.  Eric (N7JYS) Marshall's Communications

      From: Justin Grigg via arm-allstar <arm-allstar at hamvoip.org>
 To: ARM Allstar <arm-allstar at hamvoip.org> 
Cc: Justin Grigg <jgrigg at gmail.com>
 Sent: Saturday, September 16, 2017 8:08 PM
 Subject: [arm-allstar] Simplex Mode 1 Issues
   
I have a newly imaged Pi3 connected to a Repeater Builder USB-RIM Lite
Connected to a Motorola CDM-750. This is a remote link for a local repeater
that doesn't have internet access at the site.

When I had the rpt file configured for duplex=0 the node functions
perfectly without any telemetry. When I set the file for 1 as soon as the
repeater transmits the node starts a cycle of transmitting a courtsey tone,
dropping the carrier, transmitting a courtsey tone, dropping the carrier,
and so on. It continues on and on until I change the option back to 0

I am hoping this is a simple setting I am missing.

Thank you in advance!

Justin
_______________________________________________

arm-allstar mailing list
arm-allstar at hamvoip.org
http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar

Visit the BBB and RPi2/3 web page - http://hamvoip.org