[arm-allstar] No audio output from node id, time stamp etc

[John Hoser-Smith]

Doug:  It is a little misleading from a binary sense but the normal mode for
simplex operation is duplex=1 which is the default at setup.  Duplex=2 and
above is actually duplex for repeater use. duplex=0 is a special simplex
case where all telemetry is turned off and only needed in special
applications.
Question:  When setting up a RPi 3 Allstar SERVER/HUB (no Radio connected)  which Mode  (0,1,2) does Doug recommend, and why?This Server/HUB would be (just) be used for other Allstar Node(s) to connect and simultaneously share their Audio.  No Radio needed at the Server/HUB.Thanks!N0ECT 
 

    On Friday, June 9, 2017 8:41 AM, zvi.serlin--- via arm-allstar <arm-allstar at hamvoip.org> wrote:
 

 I have set up a new node with the following equipment.

Rpi3, Baofeng 888s and an Advanced Repeater Systems USB Allstar adapter portable radio version which has in put to the 888s via the mic and speaker sockets. Using the latest Rpi3 download.

Echo tests show that signals are being received and transmitted and asterisk.CLI shows dtmf being decoded and the id, status and time messages running. However none of those messages result in any audio being transmitted. Connection to another active node plays the id from the distant connection.

Duplex=0

Carrierfrom=usb

deemphasis=no

preemphasis=no

carrierfrom=usb

Reference is made in the literature to the file usbradio.conf but I only see usbradio.conf.xxx to which I have not found any mention. I assume that I have an incorrect setting in the software and hope that some one with greater knowledge of the workings can point me in the right direction.

Thanks

Zvi Serlin 4X1ZS/G3TLU
_______________________________________________

arm-allstar mailing list
arm-allstar at hamvoip.org
http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar

Visit the BBB and RPi2/3 web page - http://hamvoip.org