[arm-allstar] No audio output from node id, time stamp etc

[Doug Crompton]

John,

 I think that is what I said in my original message. The default is
duplex=1 - normal simplex mode. duplex=0 is simplex without telemetry.
Duplex=2 is normal repeater full duplex. The rest are described in the
rpt.conf file or in the documentation.

If you want to create a node without radios, such as a hub node you would
use a pseudo channel driver. Instead of

 rxchannel=SimpleUSB/usb

you would use:

rxchannel=dahdi/pseudo

in your node definition in rpt.conf


*73 Doug*

*WA3DSP*

*http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*


On Fri, Jun 9, 2017 at 12:43 PM, "John Hoser-Smith via arm-allstar" <
arm-allstar at hamvoip.org> wrote:

> Doug:  It is a little misleading from a binary sense but the normal mode
> for
> simplex operation is duplex=1 which is the default at setup.  Duplex=2 and
> above is actually duplex for repeater use. duplex=0 is a special simplex
> case where all telemetry is turned off and only needed in special
> applications.
> Question:  When setting up a RPi 3 Allstar SERVER/HUB (no Radio
> connected)  which Mode  (0,1,2) does Doug recommend, and why?This
> Server/HUB would be (just) be used for other Allstar Node(s) to connect and
> simultaneously share their Audio.  No Radio needed at the
> Server/HUB.Thanks!N0ECT
>
>
>     On Friday, June 9, 2017 8:41 AM, zvi.serlin--- via arm-allstar <
> arm-allstar at hamvoip.org> wrote:
>
>
>  I have set up a new node with the following equipment.
>
> Rpi3, Baofeng 888s and an Advanced Repeater Systems USB Allstar adapter
> portable radio version which has in put to the 888s via the mic and speaker
> sockets. Using the latest Rpi3 download.
>
> Echo tests show that signals are being received and transmitted and
> asterisk.CLI shows dtmf being decoded and the id, status and time messages
> running. However none of those messages result in any audio being
> transmitted. Connection to another active node plays the id from the
> distant connection.
>
> Duplex=0
>
> Carrierfrom=usb
>
> deemphasis=no
>
> preemphasis=no
>
> carrierfrom=usb
>
> Reference is made in the literature to the file usbradio.conf but I only
> see usbradio.conf.xxx to which I have not found any mention. I assume that
> I have an incorrect setting in the software and hope that some one with
> greater knowledge of the workings can point me in the right direction.
>
> Thanks
>
> Zvi Serlin 4X1ZS/G3TLU
> _______________________________________________
>
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>
>
>
> _______________________________________________
>
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org