[arm-allstar] New node, audio problem

[Doug Crompton]

Justin,

 The same audio comes out on both channels. We normally use A but if you
hooked it up to B that is OK you just have to set the levels with B in
simpleusb-tune-menu. Pin 22 on the URI is correct for Channel A. You have
set the A level in simpleusb-tune-menu?  Perhaps try switching in another
FOB to see if that is the problem.


*73 Doug*

*WA3DSP*

*http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*

On Tue, Feb 28, 2017 at 12:13 AM, "Justin Reed via arm-allstar" <
arm-allstar at hamvoip.org> wrote:

> Group,
> Today I installed my second Allstar node (45444, v1.5 on a Pi 2) using a
> URIx and for some reason I can't get any transmit audio (audio generated by
> the URI). I'm using Pin 22 (AC Left Out), which is what I'm pretty sure I
> used on my first setup that has been working fine.
>
> Is there some .conf file or some other place that defines whether the
> audio is sent to the left channel vs. right? I think I remember seeing that
> the right channel was for generating PL tones but I can't seem to find that
> now.
>
> Anyway, I've double-checked the cable pinouts and verified conductivity
> through the cable and everything else looks good. I'm wondering if I ended
> up with a URI with no output.
>
> Thanks for any advice you can give.
> Justin
> NV8Q
> 42640 and 45444.
>
> _______________________________________________
>
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>
>