[arm-allstar] Reset?

[David McGough]

Hi Brian,

Everything related to Linux install and config in stored on the micro-SD
card. So, each time you re-flash the SD card, you've got a completely new
install, everything reset to "factory defaults." ....Also, if you have
multiple different configs (like might be useful for emergency setups),
you can simply have multiple SD cards....Just power off the RPi2, insert
the desired card, power up, and the RPi2 has a whole new config set!

What kind of network issue are you having?

73, David KB4FXC



On Sun, 7 Jun 2015, Txlawman wrote:

> I set up my Raspberry Pi2 Allstar link node, and found some mistakes I 
had made. I am new to Linux in general and ended up just deleting the 
files, formatting the disc, re-imaging it, and running the initial setup 
program again. It still had my previous settings shown as I went through 
each one.
> 
> Also, I noticed that some of the network settings I made were not being 
changed. I have been connected a few times, but keep losing connection. A 
couple of WAY more experienced people got it connected again, but it 
dropped out again. 
> 
> Could some of this be stored in the Pi itself, and need clearing? Is 
there a hard reset procedure? is there a need for one?
> 
> Brian
> KC5YSM
> _______________________________________________
> 
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> 
> Visit the BBB web page - http://www.crompton.com/hamradio/BeagleBoneBlackAllstar/
>