[arm-allstar] DTMF tones do not show up in CLI

[larry]

Glenn since you are calling inbound from 56166 to 45308 (Your own Node) you state you have no router so how are you port forwarding or defining which UDP port is the audio port (normally 4569). Without the Port forwarding inbound calls from the outside world would normally fail Yet out bound from 45308 to the Internet should work. As well as between different Nodes on your OWN LAN as long as they have been defined in the rpt.conf [Node] section in each of your LAN nodes.
  

Larry - N7FM

On 3/31/22 11:36 AM, "Glenn Maclean via ARM-allstar" wrote:
> RAMS*CLI> rpt fun 56166 *345308
>      -- Hungup 'DAHDI/pseudo-1134897164'
> [Mar 31 11:20:23] NOTICE[349]: chan_iax2.c:4139 __auto_congest: Auto-congesting call due to slow response
>      -- Hungup 'DAHDI/pseudo-765804216'
>      -- Hungup 'IAX2/98.208.42.89:4568-350'
>      -- Hungup 'DAHDI/pseudo-1128978793'
>      -- <DAHDI/pseudo-1640261131> Playing 'rpt/node' (language 'en')
>      -- <DAHDI/pseudo-1640261131> Playing 'digits/4' (language 'en')
>      -- <DAHDI/pseudo-1640261131> Playing 'digits/5' (language 'en')
>      -- <DAHDI/pseudo-1640261131> Playing 'digits/3' (language 'en')
>      -- <DAHDI/pseudo-1640261131> Playing 'digits/0' (language 'en')
>      -- <DAHDI/pseudo-1640261131> Playing 'digits/8' (language 'en')
>      -- <DAHDI/pseudo-1640261131> Playing 'rpt/connection_failed' (language 'en')
>      -- Hungup 'DAHDI/pseudo-1640261131'
> RAMS*CLI>
>
>
> I finished installing my Node at our repeater site. It was working perfectly on the bench.  The Raspi is connected to a RLC Club Deluxe II repeater controller on port 3 with a URI and cable made for the RLC interface.  The port is set up correctly with PTT and COS working correctly.  With Asterisk CLI DTMF tones do not show up from the radio repeater receiver.  Simple USB Tune with the RX option selected shows all the DTMF tones and the modulation is set to 3.5 kHz with service monitor. When I try to connect to another node with asterisk CLI I get the above response.  I have also tried connecting to another node using Supermon and the connection fails. The RASPI is directly connected to an old Motorola Comcast modem via ethernet cable no router is involved.  I can remotely log into the RASPI from home.  I am able to ping google and get a nice response back.  Any ideas as to what may be wrong? Thanks in advance for any help.  I know enough to be dangerous about all of this!
>
> Glenn WA7SPY
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org