[arm-allstar] Command To Shut Down Node

[Greg Stahlman]

shutdown -h now
will shut it completely off.
shutdown -r now 
will shutdown and reboot

You can program a DTMF code that will do that. 


-----Original Message-----
From: ARM-allstar [mailto:arm-allstar-bounces at hamvoip.org] On Behalf Of
"Anthony (N2KI) via ARM-allstar"
Sent: Wednesday, June 22, 2022 7:33 AM
To: ARM Allstar <arm-allstar at hamvoip.org>
Cc: Anthony (N2KI) <n2ki.ham at gmail.com>
Subject: Re: [arm-allstar] Command To Shut Down Node

And after clean shut down, is there a way to DTMF a boot up?  Or do I have
to power cycle the unity?  Thanks!

Regards,

Anthony (N2KI)









On Tue, Jun 21, 2022 at 10:35 PM "Ken Rugaber via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> Yes!
>
> You may need to edit your rpt.conf file to enable.
>
> There are three commands B1, B3 and B6 probably commented out.
>
> B1 I believe shuts down
> B3 I believe restarts Asterisk
> B6 I believe reboots unit.
>
> I am doing this from memory from my cell.
>
> Ken KC9QV
>
> On Tue, Jun 21, 2022, 20:49 "Anthony (N2KI) via ARM-allstar" < 
> arm-allstar at hamvoip.org> wrote:
>
> > Hi,
> >
> > Is there a dtmf command to power down the node cleanly rather than 
> > just pulling the power cable?
> >
> > Thanks
> >
> > Anthony N2KI
> > _______________________________________________
> >
> > ARM-allstar mailing list
> > ARM-allstar at hamvoip.org
> > http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> >
> > Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
> >
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
>
_______________________________________________

ARM-allstar mailing list
ARM-allstar at hamvoip.org
http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar

Visit the BBB and RPi2/3/4 web page - http://hamvoip.org