[arm-allstar] cm108 baofeng transmit while receiving option?

[Patrick Perdue]

Channel lockout could be the issue, but the main thing here is to make 
sure linktolink is enabled. See my previous message. If this still 
doesn't work, check the radio.

If you have tones enabled, and the radio beeps at you and won't transmit 
when you press the PTT while there is activity on the frequency, that's 
channel lockout. I don't know what it does visually. Also, I don't know 
if your radio is stripped down and modded or not, so this all may not 
matter much.


On 1/4/2022 8:08 PM, "Bob Good via ARM-allstar" wrote:
> Sounds like the radio has chanel lockout enabled  it's a setting in 
> the Baofeng
>
> 73
> Bob
> VK6ZGN
>
> On January 5, 2022 08:46:18 "\"Joseph KM4OVZ via ARM-allstar\"" 
> <arm-allstar at hamvoip.org> wrote:
>
>> I’ve setup my node on a repeater, but it’s going through the cheap 
>> cm108 +
>> baofeng setup. It works great, the only problem is that if the 
>> repeater is
>> transmitting like during the long squelch tail, I cannot get the 
>> radio to
>> enter transmit mode. I’m using the DV Switch app, and I cannot make the
>> node transmit over rf while it is receiving. I think this is 
>> intentional,
>> but I wonder if there is a way to force it to ignore the RX state and
>> transmit if any incoming audio comes into the node.
>> Is there a way to do this?
>>
>> Thanks in advance,
>> KM4OVZ
>> _______________________________________________
>>
>> ARM-allstar mailing list
>> ARM-allstar at hamvoip.org
>> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>>
>> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
>
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org