[arm-allstar] cm108 baofeng transmit while receiving option?

[Dustin Perdue]

In rpt.conf, enable linktolink.

limktolink = yes
It’s probably already in your node’s stanza but commented out. If you are using your Baofeng to link to repeaters, this should help. Just remember to set duplex = 0 if you haven’t already.


Sent from my zippo


> On Jan 4, 2022, at 19:45, Joseph KM4OVZ via ARM-allstar <arm-allstar at hamvoip.org> wrote:
> 
> I’ve setup my node on a repeater, but it’s going through the cheap cm108 +
> baofeng setup. It works great, the only problem is that if the repeater is
> transmitting like during the long squelch tail, I cannot get the radio to
> enter transmit mode. I’m using the DV Switch app, and I cannot make the
> node transmit over rf while it is receiving. I think this is intentional,
> but I wonder if there is a way to force it to ignore the RX state and
> transmit if any incoming audio comes into the node.
> Is there a way to do this?
> 
> Thanks in advance,
> KM4OVZ
> _______________________________________________
> 
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> 
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org