[arm-allstar] Moto GM340 and R1-2020 Interface with Hamvoip

[David McGough]

Daren,

I haven't used the R1-2020 adapter.  Have you tried setting CTCSSFROM to 
"no" in simpleusb-tune-menu ??

73, David KB4FXC


On Sun, 3 Apr 2022, "Daren Loxley via ARM-allstar" wrote:

> Hi All.
> 
> I have an Allstar/Echolink node setup.
> All was working fine. until my Moto GM340 died (Over heated)
> I've now installed a Moto GM340 and connected up to my R1-2020 
> interface, Set to Moto on the interface and ASL.
> All well on connecting to nodes and hearing audio but I'm not able to 
> transmit any audio from the Handheld to the ASL.
> 
> I've the Alsa mixer set as 50 on both TX and RX and AGC off.
> 
> SimpleUSB as
> De-Emph Pre-Emph on.
> All else off
> COS and CTCSS USB Invert
> RX level 99
> TX Levels at 550 and DSP 999
> 
> The COS-Detected lights up as it should, the tone comes back when I 
> un-key but absolutely no voice audio comes back on either Echolink 
> Parrot or 40894 test node.
> 
> Any ideas please?
> 
>