[arm-allstar] Control-Op Codes

[Dave Petrie]

In rpt.conf  under [functions<node>] add these two lines and use whatever
numbers are available for you, I used 980 and 981.
You dtmf touch tone *980 and the transmitter shuts off  as well as link
traffic with no announcement, then when you are ready *981 to turn the
transmissions back on.
An announcement will come on "r p t enabled"  , there maybe other ways, I
have tested this one but haven't needed to use it.

981=cop,2 ;system enable
980=cop,3 ;system disable

On Mon, Oct 25, 2021 at 8:09 PM "Darrell Black via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> I have a repeater running on Allstar. How does one write a code (rpt.conf)
> to shutdown the transmitter but not the receiver so it can be disabled via
> TT and then re enable via TT when the LID is gone?
>
> --
>
> Darrell Black
>
> (517) 917-2226
> GigaHacker at gmail.com
> http://www.linkedin.com/in/darrellblack
>
>
> 73 de W8DSB
> "In God we trust, all others we monitor"
>
> GMRS WRDE739
> ALLSTAR 50964
> DMR 310195
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
>