[arm-allstar] RIM-Lite to DR1X Repeater

[Randy Neals]

Hi Mike,

I have an AllStar Node connected to a Yaesu DR1X
I purchased the ARCOM ADR-1 Interface and then interfaced the RIM from the
Raspberry Pi through the ADR-1 to the repeater.
This allowed automatic mode selection on the repeater to continue to work,
digital was repeated in the Yaesu, analog FM repeated via the AllStar Node.
https://www.arcomcontrollers.com/documents/rc210/adr.pdf



On Tue, Oct 5, 2021 at 3:37 PM "Mike Sullivan via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> Our club is looking at replacements for the CAT-250 controllers currently
> on the repeaters. One of the controllers (actually a 200) has already
> failed, while the other 250’s are okay. We are using Allstar nodes on those
> other two repeaters (via the link port) and are looking at a third to act
> as a link & a controller for the third repeater.
>
> Has anyone ever tried directly interfacing to the DR1X repeater using the
> RIM-Lite or the RIM? I’d like to take full advantage of all the features
> possible (wire up both audio pins to have one send voice, the other send PL
> tone (for tone-less repeater ID) and use the DR1X’s internal tone
> controller to allow control of functions without a PL tone.
>
> Mike
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org