[arm-allstar] Setting up Alinco DR135/235/435 for Node Use?

[B Harvey]

I have an Alinco dr-435MKIII for my node radio. Alinco doesn't supply
software with it so I used Chirp and manual programming. It's been a while
but I don't recall making any setting changes on the radio itself. If
memory servers I used the serial settings listed in the manual and
everything ran fine.


Brian
KK6DOQ

On Wed, May 12, 2021 at 6:55 AM "Chris Smart via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> Hi.
>
>
> I have the Rim-Alinco device and am about to receive a DR-435TMKIII. Do
> I need to do anything on the Alinco, like select a baud rate in order to
> obtain flat audio in and out?
>
>
> I'm asking because doing this on a Kenwood TMV71A for example, does
> require changing a few settings.
>
>
> thanks,
>
> Chris
>
>
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
>