[arm-allstar] Looping problem

[Don Rolph]

Try setting duplex to 0.

If you set duplex to 1, turn off courtesy tones with nounkeyct=1. This
however results in ping ponging of the 10 minute id of the repeater and the
AllStar node.

This is a deep nagging problem with using AllStar on a repeater link.



On Tue, May 4, 2021 at 7:45 PM "Mark Richardson via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> I am setting up an AllStar node with the plan to link it to our local
> repeater by RF.
>
>
>
> Everything is working fine if I put the radio on a Simplex frequency, but
> if
> I use a Repeater split I get a looping where the radio cycles between
> transmit and receive and a beep is heard with each cycle. It seems to begin
> the first time the radio transmits and then continues.
>
> I'm hoping someone has encountered something like this before and will have
> some suggestions for me.
>
>
>
> I am using a Standard GX3000V radio with a Masters Communications AR-35
> interface and a Raspberry PI 3.
>
>
>
> Thanks in advance,
>
> Mark Richardson
>
> VA3OBO
>
>
>
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
>


-- 

73,
AB1PH
Don Rolph