[arm-allstar] Looping problem

[Chris Smart]

Mike et al,


The repeater we're linking to via RF is not using gated pl yet... 
mentioning that in case it's a factor as well.


Chris



On 2021-05-04 9:57 p.m., "Michael Webb via ARM-allstar" wrote:
> Mark,
>
> You are describing the Ping Pong effect
>
> You can try disabling the key/unkey courtesy tones in rpt.conf
> nonounkeyct=0 (I personally don't like them or any announcements,
> especially when someone connects.)
>
> Or, you can try increasing the rxondelay setting in simpleusb.conf.
>
> Mike
>
>
> On Tue, May 4, 2021, 4:45 PM "Mark Richardson via ARM-allstar" <
> arm-allstar at hamvoip.org> wrote:
>
>> I am setting up an AllStar node with the plan to link it to our local
>> repeater by RF.
>>
>>
>>
>> Everything is working fine if I put the radio on a Simplex frequency, but
>> if
>> I use a Repeater split I get a looping where the radio cycles between
>> transmit and receive and a beep is heard with each cycle. It seems to begin
>> the first time the radio transmits and then continues.
>>
>> I'm hoping someone has encountered something like this before and will have
>> some suggestions for me.
>>
>>
>>
>> I am using a Standard GX3000V radio with a Masters Communications AR-35
>> interface and a Raspberry PI 3.
>>
>>
>>
>> Thanks in advance,
>>
>> Mark Richardson
>>
>> VA3OBO
>>
>>
>>
>> _______________________________________________
>>
>> ARM-allstar mailing list
>> ARM-allstar at hamvoip.org
>> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>>
>> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
>>
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org