[arm-allstar] Looping problem

[Michael Webb]

Mark,

You are describing the Ping Pong effect

You can try disabling the key/unkey courtesy tones in rpt.conf
nonounkeyct=0 (I personally don't like them or any announcements,
especially when someone connects.)

Or, you can try increasing the rxondelay setting in simpleusb.conf.

Mike


On Tue, May 4, 2021, 4:45 PM "Mark Richardson via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> I am setting up an AllStar node with the plan to link it to our local
> repeater by RF.
>
>
>
> Everything is working fine if I put the radio on a Simplex frequency, but
> if
> I use a Repeater split I get a looping where the radio cycles between
> transmit and receive and a beep is heard with each cycle. It seems to begin
> the first time the radio transmits and then continues.
>
> I'm hoping someone has encountered something like this before and will have
> some suggestions for me.
>
>
>
> I am using a Standard GX3000V radio with a Masters Communications AR-35
> interface and a Raspberry PI 3.
>
>
>
> Thanks in advance,
>
> Mark Richardson
>
> VA3OBO
>
>
>
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
>