[arm-allstar] FW: Multiple nodes on a LAN
David McGough
kb4fxc at inttek.net
Mon Feb 15 06:16:25 EST 2021
Joe,
Are your AllStar nodes at the same physical location, both on a single
wired LAN, with the 3GHz link back to your house?? Or, are the nodes at
different locations, both locations connected back to your house
(star configuration) via the 3GHz network??
73, David KB4FXC
On Sun, 14 Feb 2021, "Joe Borovetz via ARM-allstar" wrote:
> I have a unusual setup. The nodes are on a CradlePoint MBR-95 (I had
> it). This is behind a Pace 5268 Uverse Gateway Router. Both are at my house.
>
> The reason for the second router is this....the links to the repeaters
> run on a 3 GHz network running on ham frequency allocations. It has been
> up 6 years. I was trying to avoid any commercial traffic on the link and
> add an extra layer of security. In addition to the Allstar nodes, there
> are two P25 repeaters and a DMR repeater using this LAN.
>
> I did get it working by opening the UDP ports on the Uverse Gateway
> although I would prefer to keep it on just the LAN.
>
> I am open to any thoughts on keeping it just on the "ham" LAN". I did
> consider a router change for the second router.
>
> First thing to get it working, next solve the LAN issue. I have added
> the correct entries in rpt.conf for each of the three nodes.
>
> Would adding static routes in the MBR-95 be a solution or would a router
> change be better. I have not tried the static route method.
>
> Joe
>
>
> On 2/12/2021 10:38 PM, "Bryan St Clair via ARM-allstar" wrote:
> > Why would you not use the local LAN IP and avoid hairpin all together?
> >
> > What router do you have?
> >
> > On Fri, Feb 12, 2021 at 8:23 PM "j.borovetz--- via ARM-allstar" <
> > arm-allstar at hamvoip.org> wrote:
> >
> >> I have three nodes on the same LAN and am having problems with setting up
> >> hairpin loopback.
> >>
> >>
> >>
> >> I have followed the instructions for using multiple nodes on the same LAN.
> >> I
> >> have looked over my entries in rpt.conf multiple times and it looks like I
> >> have entered the correct information.
> >>
> >>
> >>
> >> Any thoughts as to what I might be overlooking.
> >>
> >>
> >>
> >> Joe
> >>
> >> _______________________________________________
> >>
> >> ARM-allstar mailing list
> >> ARM-allstar at hamvoip.org
> >> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> >>
> >> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
> >>
> >
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
>
More information about the ARM-allstar
mailing list