[arm-allstar] IAXRPT ?

[James R. Pilgram]

Try adding the following three lines to rpt.conf:
propagate_dtmf=yes
propagate_phonedtmf=yes
remote_dtmf_allowed=1

On Thu, Dec 30, 2021, 16:09 "Luc Drolet VE2LUQ via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> I recently installed the Hamvoip software for Rasbberry PI 2,3,4   from an
> Image  known as RPi2-3-4_V1.6-01_Allstar.exe  (2020/09/15).
>
> I then did the update  as per  menu item 1 , everything went as usual and
> I finished the configuration of a private node like  all the others that I
> maintain.
>
> After rebooting , I used  windows program iaxrpt to gain access to this
> new node and  it worked after adding a line in iax.conf  under the  iaxrpt
> stanza   as:  requirecalltoken=no.
>
> OK for this now it works , BUT:  since this version update  a very
> important feature is no longer working. This is the ability to use the
> iaxrpt program to send commands from the keypad  to connect or disconnect
> nodes or simply to ask time date or status.
>
> In my investigation I found that  the main change between the downloaded
> software and the updated software , was the change from Linux
> 4.19.65-1-1-ARCH  to 5.4.75-1-ARCH and the  GCC version changed from 8.3.0
> 2019-08-9 to 10.2.0 2020-11-9.
>
> What should we do to recover the full use of the iaxrpt windows software ?
>
>
>
> Best regards, Serge Berube  ve2abc
>
>
>
>
> Luc Drolet VE2 LUQ
>
>
>
>
>
>
>
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
>