[arm-allstar] ezstream

[Don Sayler]

Yup, set for mode 3. Looks like mode 0 might be a better choice.
I'll try that later.

On Fri, Dec 10, 2021 at 8:30 PM Don Sayler <don.sayler at gmail.com> wrote:

> Hi Dustin.
>
> I'm away from the system right now, but I think it is mode 3. I know the
> modes are listed in the conf file, we're using a multiport repeater
> controller, and the node is connected to one of those ports, as are the 4
> repeaters.
>
> I'll look later and try another duplex mode.
>
> Thanks!
>
> Don
>
>
> On Fri, Dec 10, 2021, 6:41 PM "Dustin Perdue via ARM-allstar" <
> arm-allstar at hamvoip.org> wrote:
>
>> What is your duplex mode? I think this can possibly happen if duplex=3.
>> If this is the case, and you need this for your repeater configuration, you
>> could always set up a private node just for streaming, then connect the two
>> nodes together.
>>
>> Sent from my zippo
>>
>>
>> > On Dec 10, 2021, at 21:32, Don Sayler via ARM-allstar <
>> arm-allstar at hamvoip.org> wrote:
>> >
>> > Hi Folks.
>> >
>> > With the help of Dave, I have our club's Allstar node streaming to
>> > Broadcastify. There is just one problem, the only audio being streamed
>> is
>> > that which is coming *into* our node from the Allstar network. The audio
>> > we're sending out does not seem to be getting to Broadcastify.
>> >
>> > Is there a setting somewhere that I missed?
>> >
>> > Thanks!
>> > Don W7OXR
>> > Treasurer Lake Washington Ham Club
>> > _______________________________________________
>> >
>> > ARM-allstar mailing list
>> > ARM-allstar at hamvoip.org
>> > http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>> >
>> > Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
>> _______________________________________________
>>
>> ARM-allstar mailing list
>> ARM-allstar at hamvoip.org
>> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>>
>> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
>
>