[arm-allstar] ezstream

[Don Sayler]

Hi Dustin.

I'm away from the system right now, but I think it is mode 3. I know the
modes are listed in the conf file, we're using a multiport repeater
controller, and the node is connected to one of those ports, as are the 4
repeaters.

I'll look later and try another duplex mode.

Thanks!

Don


On Fri, Dec 10, 2021, 6:41 PM "Dustin Perdue via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> What is your duplex mode? I think this can possibly happen if duplex=3. If
> this is the case, and you need this for your repeater configuration, you
> could always set up a private node just for streaming, then connect the two
> nodes together.
>
> Sent from my zippo
>
>
> > On Dec 10, 2021, at 21:32, Don Sayler via ARM-allstar <
> arm-allstar at hamvoip.org> wrote:
> >
> > Hi Folks.
> >
> > With the help of Dave, I have our club's Allstar node streaming to
> > Broadcastify. There is just one problem, the only audio being streamed is
> > that which is coming *into* our node from the Allstar network. The audio
> > we're sending out does not seem to be getting to Broadcastify.
> >
> > Is there a setting somewhere that I missed?
> >
> > Thanks!
> > Don W7OXR
> > Treasurer Lake Washington Ham Club
> > _______________________________________________
> >
> > ARM-allstar mailing list
> > ARM-allstar at hamvoip.org
> > http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> >
> > Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org