[arm-allstar] Initial setup question

[wa2zpx at juno.com]

Peter, A couple of things (from my perspective). 1) Did you try going into parrot mode and listen to what you sound like coming back? 2) Are you sure that your COS source is giving to COS keyed with COS and PL?  If it is only COS, you will see keyup on noise and interference.3) PTT Lockup.. Are you sure you have the right setting for COS in the simpleUSB menu?  


Regards, Rich WA2ZPX


> On Aug 5, 2021, at 21:33, Les Keegan via ARM-allstar <arm-allstar at hamvoip.org> wrote:
> 
> Try 40894 It will play back your audio. Not sure if it will pick up any noise but it is worth a try.
> 
> Les Keegan
> N4LPK
>> On 08/05/2021 6:19 PM Peter Dominguez via ARM-allstar <arm-allstar at hamvoip.org> wrote:
>> 
>> 
>> Hi,
>> 
>> I am very new to Allstar and I believe I have setup my Raspberry PI 4B correctly. I connected an Alinco 435T MkIII to the Raspberry Pi using the RIM-Lite Alinco card from Repeater-Builder. The Alinco is in Simplex mode on low power on 446.50 and I get the periodic announcements from the Raspberry Pi on an HT tuned to the same frequency as well as on the Alinco.  I can connect / disconnect to remote nodes using the Asterisk command line: "rpt fun 54265 *73<node>"   or  "rpt fun 54265 *73<node>".
>> 
>> When I connect to a node I hear all the traffic perfectly clear, both on the Alinco and the HT. When I transmit I do not receive a response.  However, I did receive an email from an admin stating: Your node  Periodically is locking up a ptt. Your your node is getting interference  making it key up?   Please use a pl tone on your receive and or Resolve  the issue."  I think that person blocked me from trying to reconnect to that node.
>> 
>> There isn't an Allstar repeater within radio range of my location so I could listen for what my signal sounds like. I wish there was an Allstar testing location / node such as exists for Skype where you can connect to an Allstar test number/node and it plays back your audio a few seconds later so you could hear what your audio sounds like to adjust it.
>> 
>> I would appreciate any advice on next steps.  I am familiar with tcpdump and Wireshark but hoping that is not the path I have to take.
>> 
>> Thanks,
>> 
>> Peter
>> 
>> 
>> Peter A Dominguez
>> 72 Belvedere Drive
>> Yonkers, NY 10705
>> Direct Dial: 914-423-4012
>> N2KF, Allstar: 54265, Echolink: 242205, GMRS: WRMA317
>> _______________________________________________
>> 
>> ARM-allstar mailing list
>> ARM-allstar at hamvoip.org
>> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>> 
>> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
> _______________________________________________
> 
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> 
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
_______________________________________________

ARM-allstar mailing list
ARM-allstar at hamvoip.org
http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar

Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
____________________________________________________________
Sponsored by https://www.newser.com/?utm_source=part&utm_medium=uol&utm_campaign=rss_taglines_more

GOP Official Mocked COVID. 5 Days Later, He Was Dead
http://thirdpartyoffers.juno.com/TGL3131/610d3ba89bd993ba865f5st02vuc1
Apple's Plan to Start Scanning Your Photos Worries Some
http://thirdpartyoffers.juno.com/TGL3131/610d3ba8bab8b3ba865f5st02vuc2
Cops: High School Custodian Admits Planning Mass Shooting
http://thirdpartyoffers.juno.com/TGL3131/610d3ba8d99033ba865f5st02vuc3