[arm-allstar] Initial setup question

[Aaron Groover]

Sounds like your TX level might be too low. Go into the settings via SSH and run simple usb tune menu. 

Believe it’s selection 8 in the simple usb menu. 

Respectfully,
 
Aaron Groover
(610) 379-6148

*Please excuse any grammatical errors. This message was composed on a mobile platform*



> On Aug 5, 2021, at 21:33, Les Keegan via ARM-allstar <arm-allstar at hamvoip.org> wrote:
> 
> Try 40894 It will play back your audio. Not sure if it will pick up any noise but it is worth a try.
> 
> Les Keegan
> N4LPK
>> On 08/05/2021 6:19 PM Peter Dominguez via ARM-allstar <arm-allstar at hamvoip.org> wrote:
>> 
>> 
>> Hi,
>> 
>> I am very new to Allstar and I believe I have setup my Raspberry PI 4B correctly. I connected an Alinco 435T MkIII to the Raspberry Pi using the RIM-Lite Alinco card from Repeater-Builder. The Alinco is in Simplex mode on low power on 446.50 and I get the periodic announcements from the Raspberry Pi on an HT tuned to the same frequency as well as on the Alinco.  I can connect / disconnect to remote nodes using the Asterisk command line: "rpt fun 54265 *73<node>"   or  "rpt fun 54265 *73<node>".
>> 
>> When I connect to a node I hear all the traffic perfectly clear, both on the Alinco and the HT. When I transmit I do not receive a response.  However, I did receive an email from an admin stating: Your node  Periodically is locking up a ptt. Your your node is getting interference  making it key up?   Please use a pl tone on your receive and or Resolve  the issue."  I think that person blocked me from trying to reconnect to that node.
>> 
>> There isn't an Allstar repeater within radio range of my location so I could listen for what my signal sounds like. I wish there was an Allstar testing location / node such as exists for Skype where you can connect to an Allstar test number/node and it plays back your audio a few seconds later so you could hear what your audio sounds like to adjust it.
>> 
>> I would appreciate any advice on next steps.  I am familiar with tcpdump and Wireshark but hoping that is not the path I have to take.
>> 
>> Thanks,
>> 
>> Peter
>> 
>> 
>> Peter A Dominguez
>> 72 Belvedere Drive
>> Yonkers, NY 10705
>> Direct Dial: 914-423-4012
>> N2KF, Allstar: 54265, Echolink: 242205, GMRS: WRMA317
>> _______________________________________________
>> 
>> ARM-allstar mailing list
>> ARM-allstar at hamvoip.org
>> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>> 
>> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
> _______________________________________________
> 
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> 
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org